With this goods they also buy
4.8
21.5
10.8
The author Korolev Eugene (Russia). Copying is prohibited!
ClipCoil-PRO + © is INTENDED FOR locking onto a motor shaft with a diameter of 4-5-6-6.3-8 mm.
ClipCoil-PRO + is fixed with the help of 3 stainless steel screws with an internal hexagon, which pass through the steel nuts fused into plastic.
In the clamp you can fix several wires in a row, this is necessary when you make complex windings.
ClipCoil-PRO + © is made of high-strength plastic, pressure plates made of hardened steel, with a stainless steel nut under them.
The kit includes:
- ClipCoil-PRO + © clip with a clamping screw M4 (3 mm hexagon) made of high strength steel (12)
- additional screw butterfly M4 x 25 (it can be installed if necessary)
Tip: to keep ClipCoil securely in place, a small groove can be machined on the motor shaft, this can be done with the help of a file while the motor is rotating.
ClipCoil-PRO + © is INTENDED FOR locking onto a motor shaft with a diameter of 4-5-6-6.3-8 mm.
ClipCoil-PRO + is fixed with the help of 3 stainless steel screws with an internal hexagon, which pass through the steel nuts fused into plastic.
In the clamp you can fix several wires in a row, this is necessary when you make complex windings.
ClipCoil-PRO + © is made of high-strength plastic, pressure plates made of hardened steel, with a stainless steel nut under them.
The kit includes:
- ClipCoil-PRO + © clip with a clamping screw M4 (3 mm hexagon) made of high strength steel (12)
- additional screw butterfly M4 x 25 (it can be installed if necessary)
Tip: to keep ClipCoil securely in place, a small groove can be machined on the motor shaft, this can be done with the help of a file while the motor is rotating.
 Павел |
Заказывал 8 мм, он пришол но на 0,5 мм меньше 8. Ничего страшного конечно, но дам совет расточки после печати. Здравствуйте Павел. Все внутренние отверстия (3-4-5-6-7-8 мм) после печати ОБЯЗАТЕЛЬНО рассверливаю сверлом строгого диаметра! В клипкойле на 8 мм прохожу сверлом ровно 8 мм. Если буду проходить например 8,2 мм, то в некоторых случаях у пользователей может появиться люфт, а 3мя зажимными винтами не всегда получиться точно отцентровать потом. При необходимости советую самостоятельно "проходить" сверлом 8-8,1-8,2 мм или немного нагреть ось которую нужно вставить в клипкойл и вращением вставить. Administrator10/06/2019 |
Leave a comment
See also
14
17
7
6.5
